Skip to content
Serving Livermore and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (650) 203-2763

Heating Repair in San Ramon, CA

Serving San Ramon and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (650) 203-2763

The short answer

TotalFlow repairs gas furnaces, heat pumps, and ducted heating systems in San Ramon homes, starting with a full diagnosis so you know exactly what failed. Bay Area Air District rules do not require you to replace a working furnace, so repair is often a sensible choice. If replacement does make sense, we'll walk you through how the rules and current incentives affect your options.

When your furnace or heat pump stops keeping up on a chilly San Ramon evening, you want a clear answer about what's wrong and what it will take to fix it. TotalFlow HVAC Repair Service is based in Livermore, about 10 miles southeast of San Ramon, and we repair gas furnaces, heat pumps, and ducted heating systems in homes across the 94582 and 94583 ZIP codes. We find the actual cause, explain your options in plain terms, and fix what's broken before we talk about anything bigger.

Heating Problems We Fix in San Ramon Homes

Most heating calls come down to a handful of failures. Some are simple parts that wear out. Others point to a bigger issue that needs a closer look. Either way, we test the system instead of guessing, so you aren't paying to swap parts that were working fine.

These are the problems we see most often:

  • Furnace runs but blows cool or lukewarm air
  • Burners light, then shut off after a few seconds
  • Igniter or flame sensor failures that stop the furnace from starting
  • Heat pump stuck in defrost, iced over, or not switching to heat mode
  • Blower motor that hums, rattles, or won't start
  • Thermostat that doesn't call for heat or reads the wrong temperature
  • Uneven heating, with some rooms warm and others cold
  • Short cycling, where the system turns on and off too often
  • Clogged condensate lines on high-efficiency furnaces that trip a safety switch

What Happens During a Repair Visit

Our technician starts by asking what you've noticed: when the problem began, any noises or smells, and whether it happens all the time or only sometimes. Then we check the thermostat, power, gas supply, ignition, safety controls, blower, and airflow. On heat pumps, we also check refrigerant-side operation and the defrost controls.

Before any work begins, we tell you what we found and what the repair involves. If there's more than one reasonable way to fix it, we explain the tradeoffs so you can decide. We also point out anything that looks unsafe, such as a cracked heat exchanger or a venting problem, because those issues affect more than comfort.

Repair or Replace? What Bay Area Air Rules Mean for Your Furnace

Many San Ramon homeowners have heard that gas furnaces are being phased out and wonder whether repairing an older one is worth it. Here's how the rules actually work. Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date.

The rules do not require you to replace working equipment. They apply only when an existing furnace fails or is replaced. If your furnace can be repaired safely and at a reasonable cost, keeping it running is a legitimate choice. We'll give you an honest read on its condition, its age, and whether repair money is well spent, so you can plan a replacement on your own schedule instead of during an emergency.

Thinking About a Heat Pump Instead?

If your furnace is near the end of its life, a heat pump may be worth considering, especially with the 2029 furnace standard ahead. Keep in mind that the federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations after that date.

Local help may still be available. San Ramon homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm what's currently offered before including it in any quote.

Quick Checks Before You Call

A few simple checks can save you a service visit or help us diagnose the problem faster. Make sure the thermostat is set to heat and the setpoint is above room temperature. Replace the batteries if your thermostat uses them. Check that the furnace switch, which often looks like a light switch near the unit, is on, and that the breaker hasn't tripped. Look at the air filter, because a badly clogged filter can cause overheating and shutdowns.

If you smell gas, leave the house and contact your gas utility right away. Don't try to restart the system yourself.

Serving San Ramon and the Surrounding Area

We work throughout San Ramon in Contra Costa County. We also provide heating repair in nearby Danville, Dublin, Pleasanton, Clayton, and Union City. Because we're based close by in Livermore, our technicians already know the mix of gas furnaces, heat pumps, and attic and crawlspace duct systems common in local homes.

More services in San Ramon

Related

What to expect

How a visit goes

  1. Find the cause first

    We test and inspect before recommending parts or equipment, so the fix matches the actual problem instead of a guess.

  2. Clear options, no pressure

    When a system could be repaired or replaced, we lay out both paths and the tradeoffs, then let you decide what fits your home.

  3. Current information on rules and incentives

    Air District rules and rebate programs change. We confirm what applies today before we talk about it, so you can plan with accurate information.

FAQ

Common questions

Do I have to replace my gas furnace because of the new Bay Area rules?

No. Bay Area Air District appliance rules don't require replacing working equipment. They apply only when an existing furnace fails or is replaced. Under Rule 9-4, gas furnaces manufactured from 2029 on must meet a zero-NOx standard.

Is it worth repairing an older furnace?

Often, yes. It depends on the furnace's condition, the type of repair, and how its safety components look. We'll tell you honestly whether a repair makes sense or whether it's time to start planning a replacement.

Can I still get the federal tax credit for a heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and it doesn't apply to new installations after that date. You can check BayREN and your local clean energy provider for current incentives.

Do you repair heat pumps as well as furnaces?

Yes. We repair heat pumps, gas furnaces, and ducted heating systems, including problems with defrost, reversing valves, blowers, controls, and thermostats.

Why does my furnace turn on and then shut off right away?

Common causes include a dirty flame sensor, a clogged filter causing overheating, a blocked condensate line, or a venting problem. A technician should test the system to find the actual cause.

Which ZIP codes in San Ramon do you serve?

We serve homes in both San Ramon ZIP codes, 94582 and 94583, along with nearby Danville, Dublin, Pleasanton, Clayton, and Union City.

Need Heating or Cooling Help in Livermore?

Tell us what your system is doing, or not doing, and we'll schedule a visit to find the cause and walk you through your options.

(650) 203-2763
Call (650) 203-2763 Request Service