Skip to content
Serving Livermore and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (650) 203-2763

Furnace Installation in Livermore and the Tri-Valley

Serving Livermore and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (650) 203-2763

The short answer

You likely need a new furnace if your current one is failing often, heating unevenly, or has a safety problem like a cracked heat exchanger. We inspect the whole system first, then lay out repair and replacement options, including gas furnaces and heat pumps, so you can choose with the full picture.

A new furnace is a major decision, and it rarely comes at a convenient time. Maybe your current unit quit on a cold night, or you've been paying for repair after repair and want to know if replacement makes more sense. TotalFlow HVAC Repair Service helps homeowners in Livermore, Pleasanton, Dublin, San Ramon and nearby cities sort out those questions with a clear inspection and straightforward options. This page explains the signs that point toward a new furnace, what we look at before recommending anything, how we weigh repair against replacement, what drives the cost of an installation, and what to expect when we come out. You'll also find a short note on the Bay Area Air District rules that affect gas furnaces, since they matter for anyone planning a replacement.

Signs You May Need a New Furnace

Furnaces usually give warning before they fail for good. One symptom on its own often means a repair, but several together are a good reason to have the system evaluated for replacement.

If any of the safety-related signs below apply, such as a carbon monoxide alarm or a smell of gas, turn the furnace off, leave the house if needed, and contact your gas utility or emergency services before calling us.

  • Repairs are becoming frequent, and each fix only buys a short stretch of reliable heat
  • Some rooms stay cold while others overheat, even after filters and vents are checked
  • The furnace short-cycles, turning on and off more often than it should
  • You hear banging, rattling or screeching when the system starts or runs
  • The burner flame looks yellow or flickering instead of steady blue
  • Heating bills keep climbing without a change in how you use the system
  • A technician has found a cracked heat exchanger or another safety issue
  • Your carbon monoxide alarm has gone off

What We Check Before Recommending Anything

A furnace is only one part of your heating system, so we look at how everything works together. A new furnace connected to leaky ducts or the wrong venting won't perform the way it should, and replacing equipment that only needs a repair wastes your money.

During the inspection we look at the furnace itself and the parts of the house it depends on:

  • Heat exchanger condition, burners, ignition and flame quality
  • Blower motor, belts or direct-drive components, and airflow
  • Venting and flue connections, including signs of backdrafting
  • Gas supply connections and shutoff, or electrical capacity for an electric option
  • Ductwork for leaks, disconnected runs and poorly insulated sections
  • Thermostat operation and wiring
  • Filter access, return air size and the space around the unit
  • The size of your home and whether the current furnace is properly matched to it

Repair or Replace: Your Options

We give you the honest answer on whether repair is reasonable. If a worn igniter, flame sensor or blower part is the problem and the rest of the furnace is in good shape, a repair is often the sensible choice. If the heat exchanger is cracked, major parts are failing at the same time, or the unit has needed repeated work, replacement usually makes more sense.

When replacement is the right call, you generally have two paths. One is a new gas furnace, often paired with an existing or new air conditioner. The other is a heat pump, which heats and cools with a single system and runs on electricity. Some homes use a dual-fuel setup that combines a heat pump with a gas furnace for backup.

It helps to know the local rules. Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard, which in practice points homeowners toward heat pumps when a furnace is replaced after that date. These rules do not require you to replace working equipment; they apply only when an existing furnace fails or is replaced. If you're replacing now, it's still worth thinking about where your home is heading over the life of the new system.

On incentives: the federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025, and it isn't available for new installations now. Bay Area homeowners can still check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before including it in any quote.

What Affects the Cost of Furnace Installation

Every home is different, so we don't quote a price until we've seen the system. These are the main factors that move the cost up or down:

  • The type of system: gas furnace, heat pump or dual-fuel
  • Efficiency level and features such as variable-speed blowers or multi-stage heating
  • The correct size for your home, based on a load calculation rather than the old unit's label
  • Location of the equipment, such as an attic, crawlspace, garage or closet
  • Venting changes, which are common when moving to a higher-efficiency furnace
  • Ductwork repairs, sealing or replacement
  • Electrical upgrades, which are sometimes needed for a heat pump
  • Permits and inspections required by your city
  • Removal and disposal of the old equipment

How a Visit Works

When you contact us, we'll ask a few questions about your current system and what's going on, then schedule a time that works for you. Our technician will inspect the furnace and related components, explain what they find in plain terms, and answer your questions on the spot.

If replacement makes sense, we'll walk you through the options that fit your home and budget and give you a written quote that spells out the equipment and the work included. There's no pressure to decide that day.

On installation day, we protect your floors and work area, remove the old unit, install and connect the new system, and test it for safe operation, proper airflow and correct thermostat control. Before we leave, we show you how to change the filter and use the thermostat, and we handle the permit inspection scheduling where required.

What to expect

How a visit goes

  1. Find the cause first

    We test and inspect before recommending parts or equipment, so the fix matches the actual problem instead of a guess.

  2. Clear options, no pressure

    When a system could be repaired or replaced, we lay out both paths and the tradeoffs, then let you decide what fits your home.

  3. Current information on rules and incentives

    Air District rules and rebate programs change. We confirm what applies today before we talk about it, so you can plan with accurate information.

FAQ

Common questions

How long does a furnace installation take?

A straightforward replacement in the same location often takes about a day. Jobs that involve ductwork, venting changes, electrical upgrades or switching to a heat pump can take longer. We'll give you a time estimate with your quote.

Do I have to replace my gas furnace because of the Air District rules?

No. The Bay Area Air District rules don't require replacing working equipment. They apply only when an existing furnace fails or is replaced. Starting in 2029, new gas furnaces manufactured for sale must meet a zero-NOx standard, which points most replacements after that date toward heat pumps.

Can I still get a federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations now. Check BayREN and your local clean energy provider for current incentives; we confirm any offer before quoting it.

Is a bigger furnace better?

Not necessarily. An oversized furnace tends to short-cycle, which can cause uneven temperatures and extra wear. We size the system to your home using a load calculation.

Should I replace my air conditioner at the same time?

It depends on the age and condition of your AC. If it's older or uses an outdated refrigerant, replacing both together can make sense. We'll tell you whether your current AC is a good match for a new furnace.

Which cities do you serve?

We serve Livermore and nearby cities, including Pleasanton, Dublin and San Ramon. Contact us to confirm service in your area.

Need Heating or Cooling Help in Livermore?

Tell us what your system is doing, or not doing, and we'll schedule a visit to find the cause and walk you through your options.

(650) 203-2763
Call (650) 203-2763 Request Service