Skip to content
Serving Livermore and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (650) 203-2763

Heat Pump Installation in Union City, CA

Serving Union City and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (650) 203-2763

The short answer

A heat pump heats and cools your Union City home with one electric system, and it's often the most practical replacement when your furnace or AC is near the end of its life. Bay Area air rules don't force you to replace working equipment. They do steer new furnace purchases toward heat pumps starting in 2029, so it's worth planning ahead.

If you're thinking about replacing an aging furnace, an air conditioner, or both in your Union City home, a heat pump can do the work of both systems. TotalFlow HVAC Repair Service installs heat pumps for homeowners across Union City and the 94587 ZIP code. We're about 14 miles northeast in Livermore, so getting to you is a short drive. This page covers how we decide whether a heat pump fits your house, what local air rules mean for your timing, how installation works, and where to look for current incentives.

Is a Heat Pump the Right Fit for Your Union City Home?

A heat pump moves heat instead of burning fuel to make it. In winter it pulls heat from outdoor air into your home. In summer it runs in reverse and works like a central air conditioner. For many households, that means one outdoor unit and one indoor unit replace both a gas furnace and a separate AC.

Whether it fits your house depends on a few specifics. Our first visit focuses on these:

  • Your existing ductwork: its condition, sizing, and whether it leaks
  • Your electrical panel: whether it has room and capacity for the new circuit
  • Rooms without ducts, such as additions or converted garages, where a ductless mini-split may work better
  • How old your current furnace and AC are, and their condition
  • Where the outdoor unit can sit with good airflow and reasonable distance from bedrooms and neighbors

What Bay Area Air Rules Mean for Your Timing

The Bay Area Air District has adopted rules that affect home heating. Gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date.

These rules don't require you to remove equipment that still works. They apply only when an existing furnace or water heater fails or is replaced. If your furnace is running well, you don't have to act now. If it's old or needs frequent repairs, though, planning a heat pump installation on your own schedule is usually easier than replacing a system in a hurry during a cold snap.

Water heaters have a separate rule. The zero-NOx date for small water heaters was set for 2027, and the Air District Board has been considering amendments this November that could push it back. Check the current rule before you plan a water heater replacement. We can talk you through how it might affect a heat pump water heater decision.

How We Size and Plan Your Installation

A heat pump that's too large cycles on and off, wastes energy, and handles humidity poorly. One that's too small runs constantly on cold mornings. So we size equipment based on your actual house, not just the size of the unit you have now.

We look at square footage, insulation, window area, which way the house faces, and how your family uses each room. If we find duct problems, such as crushed runs, disconnected joints, or undersized returns, we explain what we found and what fixing it would involve, so you can decide before work begins.

What Installation Day Looks Like

Most ducted replacements follow the same general sequence. We tell you ahead of time how long your home will be without heating or cooling.

  • Protect floors and work areas, then disconnect and remove the old furnace, AC, or both
  • Set the outdoor unit on a level pad and install the indoor air handler or coil
  • Run refrigerant lines, the condensate drain, and the electrical connections
  • Pressure-test and evacuate the refrigerant lines before charging the system
  • Install and set up the thermostat, then test the system in both heating and cooling modes
  • Walk you through operation, filter changes, and what normal heat pump sounds and defrost cycles look like

Incentives and Tax Credits

The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date, so don't count on it when budgeting a project now.

Local programs may still help. Union City homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm what's currently offered before including it in a quote.

Serving Union City and Nearby Communities

We install heat pumps throughout Union City (94587) and nearby Alameda County communities, including Hayward, Newark, Fremont, Pleasanton, and Dublin. If you're comparing options, we're happy to look at your current system and give you a straight answer on whether a heat pump makes sense now or later.

More services in Union City

Related

What to expect

How a visit goes

  1. Find the cause first

    We test and inspect before recommending parts or equipment, so the fix matches the actual problem instead of a guess.

  2. Clear options, no pressure

    When a system could be repaired or replaced, we lay out both paths and the tradeoffs, then let you decide what fits your home.

  3. Current information on rules and incentives

    Air District rules and rebate programs change. We confirm what applies today before we talk about it, so you can plan with accurate information.

FAQ

Common questions

Do I have to replace my gas furnace with a heat pump?

No. Bay Area Air District rules don't require replacing working equipment. They apply only when a furnace or water heater fails or is replaced, and furnaces manufactured from 2029 must meet a zero-NOx standard.

Can a heat pump replace both my furnace and my air conditioner?

Yes. A heat pump provides heating and cooling from one system, so it typically replaces both. In many homes it can use the existing ductwork.

Will I need an electrical panel upgrade?

Sometimes. It depends on your panel's capacity and available space. We check this during the first visit so there are no surprises later.

Can I still get the federal tax credit for a heat pump?

No, not for new installations. The 25C credit covered qualifying heat pumps placed in service before December 31, 2025.

Are there local rebates for heat pumps in Union City?

Possibly. Check BayREN and your local clean energy provider. Offers change by funding cycle, so we confirm current availability before quoting anything.

What if part of my house doesn't have ducts?

A ductless mini-split can heat and cool rooms without ductwork, such as additions or converted spaces. It can run on its own or alongside a ducted system.

Need Heating or Cooling Help in Livermore?

Tell us what your system is doing, or not doing, and we'll schedule a visit to find the cause and walk you through your options.

(650) 203-2763
Call (650) 203-2763 Request Service